Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: j2mariashop on December 29, 2022, 05:08:42 PM
-
When I open the Rounding canned cycle on my Windows 10 laptop I find that after using the cycle several times I cannot open the wizard. I get an error message: "unable to show wizard 4: expected a "wxcolour" for parameter 2, but got a 'nil'.
I contacted ArtSoft and the response was that this is a rare Windows error and was told to download Mach4 Industrial in demo form and use the rounding cycle from there. I did that on another laptop (a Surface) but after a few days, I get the same error on that laptop too.
Shutting down and restarting doesn't make any difference. It is as the cycle code has been permanently corrupted.
Any suggestions?
Joe
-
Scanning the posts in the forum it looks like several people have the identical issue, usually with the rounding canned cycle. Anyone have any thoughts?
Joe