Machsupport Forum

Mach Discussion => Mach3 under Vista => Topic started by: geo672 on December 02, 2022, 08:11:39 PM

Title: Motors run for jog but x,z display frozen
Post by: geo672 on December 02, 2022, 08:11:39 PM

Recently bought older cnc lathe.  New to forum but did not find this problem.  I am running on a system 7 pc and the controller is an older xhc mach3 motion card.  Motors respond correctly for jog but x,z display frozen (not updating)

Title: Re: Motors run for jog but x,z display frozen
Post by: geo672 on December 09, 2022, 02:01:33 PM

Turns out config native units was inches and controller is metric.  I changed the native units to metric and it fixed it.