Mach Discussion => Mach4 General Discussion => Topic started by: DanP on November 26, 2022, 03:42:07 PM
Title: Motion Problem
Post by: DanP on November 26, 2022, 03:42:07 PM
Building a New Router running Mach4 ESS and C25XP testing motion it jogs every direction perfect,Homes Perfect will run gcode as long as i am using G0 if i use G1 G2 G31 G83 nothing on motion no error. Not sure where to look Mach4?? ESS?? C25XP??. I am testing with Gcode that my mill runs fine Mach4 ESS MB3. Any advice is welcome. Started with 4818 ESS 275 i think, tried up grading to 5000 Ess 284 No Change.
Title: Re: Motion Problem
Post by: DanP on November 26, 2022, 06:19:23 PM
Never mind got it!
Title: Re: Motion Problem
Post by: daniba73 on November 27, 2022, 02:48:35 AM
where was error?
Title: Re: Motion Problem
Post by: DanP on November 27, 2022, 01:55:04 PM
Changed feed mode from Per Rev to Per min. Now everything works as expected.
Title: Re: Motion Problem
Post by: Trensica on July 27, 2023, 11:46:09 PM
Great! I read your post and I also exchange Per Rev. The best result I want.