Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ToniCM on November 17, 2022, 02:24:32 PM

Title: Mach3 Z safe setting vs VCarve safe Z setting
Post by: ToniCM on November 17, 2022, 02:24:32 PM

Hi there.
Does anyone know wether Mach3 safe Z setting overrides Vcarve safe Z one or viceversa?
Thanks in advance.

Title: Re: Mach3 Z safe setting vs VCarve safe Z setting
Post by: olf20 on November 17, 2022, 07:31:35 PM

I use Mach3 and VcarvePro. I have always
used the Z settings in VcarvePro.
Exception is when re starting from a feedhold.
Then Mach3 will pop up a partial screen that
asks you to allow Mach3 to move via the safeZ
in setting in Mach3 and as shown in the popup.
olf20 / Bob