Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: laurent.milhet on November 07, 2022, 10:22:09 AM

Title: anti collision
Post by: laurent.milhet on November 07, 2022, 10:22:09 AM

Hello, I bought an icon integra card with arc pro for a plasma table, with mach 4.
My table is equipped with an anti-collision support on the P11input1 input which will be used for the PROBE and I would like to be able to use the same input to block the machine in the event of contact outside the PROBE. (during JOG and cut)
I can attach my Mach 4 setup if you want. Thanks in advance Laurent.

Title: Re: anti collision
Post by: Vital System Support on November 07, 2022, 03:46:05 PM

Hello Laurent,

We aren't currently supporting this feature, but it is on the list of features to add in the future. We recommend properly configuring your Tip Voltage Anti-Dive as well as Minimum Cut Height in the ArcPRO settings table to prevent collisions with the material.