Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: teckn0 on October 03, 2022, 07:19:05 AM

Title: Calling Touch Probe Functions from an Xbox Controller
Post by: teckn0 on October 03, 2022, 07:19:05 AM

I’d like to call the TouchCenter0 and TouchOffZNeg0 functions from the TouchOff module by pushing xbox controller buttons. Is this technically possible? If so, can someone help me with what I need to do as far as scripting and / or configuration to accomplish this?

-Thanks

Title: Re: Calling Touch Probe Functions from an Xbox Controller
Post by: teckn0 on October 09, 2022, 07:45:01 AM

I ended up writing a custom mcode specific to my edge finder and calling it from one of the Xbox user gcode registers.

-Thanks