Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: frapo on July 30, 2022, 03:51:47 AM

Title: mach3 xhc WHB04B mini lathe
Post by: frapo on July 30, 2022, 03:51:47 AM

hi i have the XHC WHB04B pendant and i like it very much,but there is one thing that i cant find out.
The z axe dro output are the same on pc and pendant,but my x axe shows different numbers,e.g- x axe on pc 100 mm  and the pendant shows 50 mm or is that normal.

Title: Re: mach3 xhc WHB04B mini lathe
Post by: JohnHaine on July 30, 2022, 09:10:21 AM

Lathe set to diameter mode but the pendant either isn't set or doesn't recognise it.  Mach 3 should say diameter mode under the dros.  Just ignore the pendant.