Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: James Hui on July 24, 2022, 11:38:07 PM

Title: MACH3 is unable to load G-code generated from Fusion 360
Post by: James Hui on July 24, 2022, 11:38:07 PM
Hi, Good Day
I have a problem need help. I generated a G-Code ( file extension . nc) from Fusion 360 and would load it to my MACH3. But I got the following message on the MACH3 G-code display window "The Postprocessor is a sample for MACH3. For more information on how to update your post processor to review http://knowledge.sutodesk.com/community/article/3   . But I cannot find this article.

Many Thanks in advance ,

James
Title: Re: MACH3 is unable to load G-code generated from Fusion 360
Post by: JohnHaine on July 28, 2022, 12:19:10 PM
Change the file extension to .txt and try again?