Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: ETC Don on July 15, 2022, 08:34:12 AM

Title: Alarm 27 NO AXES COMMANDED IN G43/G44
Post by: ETC Don on July 15, 2022, 08:34:12 AM

I'm using a Right Angle Head and I'm not able to figure out what's causing this error.
I've attached a G-Code file that's giving the error.  I know there is an issue in the combination of machine and control definitions and post file in mastercam, but I should be able to see the result in the G-Code.  I'm just not seeing what's causing the issue.  I have other programs that use the RAH without any issues.
Thanks for any help.

Title: Re: Alarm 27 NO AXES COMMANDED IN G43/G44
Post by: ETC Don on July 25, 2022, 02:20:46 PM

Has anyone seen this error or used a RAH?
I'm just not sure what I'm missing.

Title: Re: Alarm 27 NO AXES COMMANDED IN G43/G44
Post by: ETC Don on July 27, 2022, 01:02:47 PM

For anyone that stumbles on this, it turns out my post file was not adding a Y value after the

N350 G18 G43 H42

I added Y0.001, and have been good since.