Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: yelims20 on May 20, 2022, 06:03:28 PM

Title: inputs for alarms
Post by: yelims20 on May 20, 2022, 06:03:28 PM

Anyone have any good ideas about how to map an alarm from a servo? If one servo stopped, it would be nice for the Integra to know about it and not keep driving the other axis... what about a low way lube level alarm?  I know I can run them to an input pin, then what? Unless I map it as an over travel, it'll just turn on an LED and not act upon the alarm.
Thanks
Mark :)

Title: Re: inputs for alarms
Post by: yelims20 on May 20, 2022, 10:20:15 PM

this pretty much takes care of it... Thank you Craig!
https://www.machsupport.com/forum/index.php?topic=38727.msg261692#msg261692