Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Mark Skev on May 13, 2022, 09:19:26 AM
-
Hi,
I'm new to this forum so forgive if don't know the etiquette.
i have just bought a CNC router with Mach 3 installed and am using it for the first time. We are a CNC shop so have modified a Post from our CAD system and have ran the programs successfully.
The problem i have is when i use the HOLD button when i want to pause the program. When i press the start button to carry on, the machine ignores the next feed rate and rapids down into the job where as If i let the program run without interruption, then it's fine.
I am guessing there is a setting somewhere that needs altering??
I would appreciate some expert advice.
Thanks