Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mjzrpr on April 22, 2022, 02:07:50 PM

Title: mkx-et problem
Post by: mjzrpr on April 22, 2022, 02:07:50 PM

hi
the china mach3 board (mkx-et) in joging and homing can not slower than 200 hz speed.
how can solve this?
by increasing "step per" in motor tuning , minimum speed of axis can be slow.
when "step per" equal to 200 , minimum jog is 1mm/s.
thanks

Title: Re: mkx-et problem
Post by: mjzrpr on April 23, 2022, 04:50:41 AM

There seems to be no support for china mkx-et.
when g28.1 or referencing on gcode , the gcode start from first.
may be from plugin ...