Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Madcnc on April 15, 2022, 11:33:07 PM
-
Hi All hoping someone can help.
I have a issue with probing not working correctly I'm using Mach4 ver 4612 with ESS ver 275 .
When I use G31 to probe the job surface everything seems to work correctly till it ends then when asked to return to G53 Z0 it moves towards the table instead of up why?? I have spent days trying to sort this out but to no avail, has anyone else had this problem ? any assistances would be much appreciated