Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Ambico87 on April 12, 2022, 11:45:55 PM

Title: Clearpath Servos are enabled, but wont move in Mach3
Post by: Ambico87 on April 12, 2022, 11:45:55 PM

I can't figure out what I am doing wrong.  I have a C-10 BOB with USB smoothstepper.  I'm using the standard cable from Teknic for the servos and verified my wires are pinned correctly inside my enclosure.

The LED on the servo is rapidly blinking green. I have my white and black wires connected to pins 2 and 3 and the yellow and brown wires connected to ground.

I connected the software to tune the motor and that worked fine, but nothing happens in Mach3.

I have tried changing several settings but I feel like I'm missing something and cannot seem to find a configuration guide for Mach3.

Any ideas?

Title: Re: Clearpath Servos are enabled, but wont move in Mach3
Post by: JohnHaine on April 18, 2022, 07:39:12 AM

Have you got the Mach3 manual?

Title: Re: Clearpath Servos are enabled, but wont move in Mach3
Post by: JohnHaine on April 18, 2022, 07:39:39 AM

Newfangled solutions website

Title: Re: Clearpath Servos are enabled, but wont move in Mach3
Post by: Ambico87 on April 18, 2022, 08:01:57 PM

Fixed it! In case anyone else has this issue. The C-10 breakout board must have the COM jumper flipped.