Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: spaldinggardener on March 28, 2022, 01:26:39 PM

Title: Mach3
Post by: spaldinggardener on March 28, 2022, 01:26:39 PM

Hi there i am running Mach3 fully licensed and have change to a new Super USB interface MACH3 100Khz Board 4 Axis Interface Driver Motion Controller recommended by artsoft the trouble i am having is when i run mach 3 in simulation mode it will do thousands of line, when mach 3 is connected to the motion controller it will only do 500 line then stop.

Any help would be good

Pete

Title: Re: Mach3
Post by: 01sporty on March 28, 2022, 02:32:37 PM

You're in demo mode.  Look for your Mach1Lic.dat file and put it in the Mach3 directory.

Title: Re: Mach3
Post by: spaldinggardener on March 28, 2022, 04:15:35 PM

Hi there i will try that thanks
Pete

Title: Mach 3
Post by: spaldinggardener on April 01, 2022, 07:24:51 AM

Hi there i have a problem with mach3 running on windows 7 64 bit i have a full licence.

I have now installed a motion controller all works ok but it will not go above 500 line

Any help would be good

Title: Re: Mach 3
Post by: joeaverage on April 01, 2022, 05:45:34 PM

Hi,

Quote

I have now installed a motion controller all works ok but it will not go above 500 line

Then Mach is in Demo mode. You may have a license but it is not in the right folder or corrupt or something.

Craig.

Title: Re: Mach3
Post by: TPS on April 03, 2022, 04:44:29 AM

you need to have a valide  licence file

Mach1Lic.dat

in C:\Mach3