Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Ts on March 14, 2022, 06:33:34 PM
-
I purchased a Used cnc router it was all disassembled When I got it I have it re-assembled and I am trying to get it up and running I have it to the point now where the servo motors are moving an XYZ and I’m trying to get the spindle to operate it has the Huanyang 220v 2.2kw vfd I am using the Mach3 software and I have it to the point where I can turn the spindle off and on with Mach3 but I cannot control the speed I have read some of the other post and tried some of those settings but have had no success any help would be greatly appreciated
-
Without knowing more about the hardware you have it's hard to advise.
-
need help getting Mach3 to control the spindle here’s what I have I have
warp 9ESS
c35s Break Out Board
c15 dual relay board
c41 variable speed control
Huanyang 220v 2.2kw vfd
I bought this as a project but didn’t get a computer with it so I’m basically starting from scratch and I have no idea why it’s wired the way it is I’m starting to trace wires now to see what the previous owner has done on the VFD he has a wire on the FOR post the DCM the ACM and the V1I would post pictures but for some reason I cannot on this form board
-
Hi Ts,
This thread explains how to post attachments / pictures to the forum; https://www.machsupport.com/forum/index.php?topic=24585.msg173822#msg173822
Hope this helps.
Tweakie.
-
I don't understand what you mean by "the VFD he has a wire on the FOR post the DCM the ACM and the V1I ". If the C41 is the device from CNC4PC then the manual is here:
https://www.cnc4pc.com/pub/media/productattachments/files/c41s-r1.1_user_manual_v1.pdf
With that and the Mac3 manual from NFS you should be able to work it out.