Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: laheyth on March 14, 2022, 04:18:08 PM
-
I have Mach 3 that I run on my machine, and another copy that I keep on my programming computer, they both run Windows 10
I have started to see an issue when I run a program on my programming computer where it will start a program and go to the M30 block and then just stop, and after about 5 sec it will rewind and go back to the first block.
I can take the same program, attached, and run it on the machine fine......I dont understand it.
Any thoughts on how to fix this?
Tom