Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Gerhard_68 on March 01, 2022, 07:11:16 PM
-
Hi
tried to use the canned cycles in MACH4 lathe version.
The work all, but all of them use tool number 1.
Could not find how I can define another tool.
If I set a toolchange in settings I find it in Gcode,
but some lines later switched back to tool 1.
So I have to delete this tool1 line from Gcode.
Tried to use grove wizzard, works also with tool0101, but I dont find
how to enter the tool width of my parting tool.
Must this be defined in the tooltable?
Regards
Gerhard