Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mrmacca on February 07, 2022, 10:31:57 AM

Title: Mach3 Motor Tuning wont save
Post by: mrmacca on February 07, 2022, 10:31:57 AM

Problems with saving step and dir pulse in mach 3 motor tuning , each time i save all 3 axis and each time returns to zero , no matter how many times i cange and shave axis settings and then save settings it goes straight back to zero , running it on windows 10 and this has only just started happening.
cheers

Title: Re: Mach3 Motor Tuning wont save
Post by: fixittt on February 17, 2022, 03:23:04 PM

Look in the motor outputs to make sure they are enabled and have pins and port number specified. If it just started doing this, then see if you can recover the XML from a previous run.