Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: mikealex1970 on January 26, 2022, 01:53:36 PM

Title: program goes to top line in mach4 while running a program
Post by: mikealex1970 on January 26, 2022, 01:53:36 PM

I am running mach4 with plasma and during a program run it will randomly send to top of program for no reason

Title: Re: program goes to top line in mach4 while running a program
Post by: SwiftyJ on January 26, 2022, 01:57:23 PM

I have noticed something similar. Does it jump up to around line 3 and then back down to where it was? For me it does it after probing/initial height sense

Title: Re: program goes to top line in mach4 while running a program
Post by: mikealex1970 on January 26, 2022, 08:31:35 PM

it goes to line 2 and leaves the torch on and no movement