Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: cousinit75 on January 14, 2022, 08:07:25 AM

Title: UC100 controller
Post by: cousinit75 on January 14, 2022, 08:07:25 AM

Just got uc100 controller installed to replace the parallel cable. Ill try to add some pics of what the original  motor outputs were,and what they are now. I have movement on the x and y but only one direction (using keyboard) i dont have any movement on z, all motors are getting power. All help appreciated.

Title: Re: UC100 controller
Post by: Graham Waterworth on January 14, 2022, 07:34:07 PM

You need to set the port and pins the same as the old LPT setup

Title: Re: UC100 controller
Post by: cousinit75 on February 06, 2022, 02:33:12 PM

Thanks Graham . I managed to get direction sorted on x and y and the z was a problem with the motor but got that freed up and now have full movement.