Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: mikealex1970 on December 31, 2021, 01:38:05 PM

Title: ArcPro 7866 Plasma Combo
Post by: mikealex1970 on December 31, 2021, 01:38:05 PM

I am new to mach4 and just upgraded my plasma table to use the 7866 module.  I had the myplasm originally.  I am using sheetcam to do the post processing and was wondering what post processor works best for mach4 with the arcpro 7866

Title: Re: ArcPro 7866 Plasma Combo
Post by: aaronky on January 20, 2022, 08:28:56 PM

Not sure about the arcpro table. What type of THC do you have?

Title: Re: ArcPro 7866 Plasma Combo
Post by: mikealex1970 on January 21, 2022, 01:37:16 PM

it is built into the 7866 module

Title: Re: ArcPro 7866 Plasma Combo
Post by: SwiftyJ on January 21, 2022, 04:08:58 PM

There should be a sheetCAM Mach4 post with no Z moves which I think you can use. I think the ArcPro screen has DROs for setting cut heights etc. on the screen which are read in the M3/M5 macros. If not best to ask Vital Systems