Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: Somtter on December 30, 2021, 06:26:37 PM

Title: On/Off for hand motor router
Post by: Somtter on December 30, 2021, 06:26:37 PM

Hello, can anyone help me?
I have installed Mach4 and I already have my motors and limits , but I cannot get a signal to turn on and off the handheld router that I have installed. I can't get the output signals from my XHC card to work. (Modbus is not present in the plugins, could that be?)
Greetings.

Title: Re: On/Off for hand motor router
Post by: rufustoad on December 31, 2021, 10:14:54 AM

Have you enabled your spindle on in the plug in tab and mapped it on your outputs config?