Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: aliorix on December 09, 2021, 09:58:15 AM

Title: [Help] Usb board don't trigger e-stop or home/end switches
Post by: aliorix on December 09, 2021, 09:58:15 AM

Hi everyone  :D

Im still trying to finish my build but after some good progress (motor working good, all ports and pins configured) i get stuck trying that this Breakout board recognise when i press the end stops, home or emergency stops... 
Everyting is wired like they said, i move the motor and when i press the endstops the motor continue like nothings happen  >:(

This is the board:
(https://ae01.alicdn.com/kf/H815bd7a90dd54c7f9dbac87d6f9d5295G.jpg)

It came with a cd with some plugin that is that i already put, and a manual that sais the numbers of ports and pins

I don't have anything more than that. So i suspect that im not geting something.

This is the wiring diagram
(https://www.buildyourcnc.com/images/mach3USBCardWiringdiagram-800.jpg)


Any idea from where to start checking?

Title: Re: [Help] Usb board don't trigger e-stop or home/end switches
Post by: coryfulton on March 21, 2022, 02:43:14 AM

Do you find what it cause that or how it is solved?