Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Ktmrider2005@hotmail.com on November 17, 2021, 12:38:55 PM

Title: THC301 screen set and post processor file???
Post by: Ktmrider2005@hotmail.com on November 17, 2021, 12:38:55 PM

Howdy everybody!

I recently bought a slightly used plasma route Blaze HD plasma table with 80A cutmaster and THC301 made by texasmicrocircuits. However the computer it came with had a bad hard drive. So I installed a new hard drive and installed mach3. Machine works and cuts but I cannot for the life of me find the install file for the Torch Height Control. ( PR301 )made by texasmicrocircuits. Does anyone have the screenset/install file for THC301?

THC30x.EXE or THC30x.ZIP

Also trying to see if if someone has a post processor set up specifically for using the THC301??

Title: Re: THC301 screen set and post processor file???
Post by: 50sCarStuff on November 17, 2021, 02:01:35 PM

I'm also looking for an installation manual or input and output pin numbers.
I would appreciate any help.