Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mttopcarver on October 14, 2021, 05:33:10 PM

Title: im lost
Post by: mttopcarver on October 14, 2021, 05:33:10 PM

just finished building prototype 2 cnc router think i got all the settings right in mach3. I can even run the roadrunner file. but if open a file from easel it stops at 300 lines. vcarve test file also stops at 300 lines

Title: Re: im lost
Post by: Tweakie.CNC on October 14, 2021, 05:57:55 PM

Hi mttopcarver,

Welcome.

In Demo mode Mach3 will only run approx. 500 lines of code. Once the Mach3 license is installed that limit is removed.

Tweakie.

Title: Re: im lost
Post by: mttopcarver on October 14, 2021, 06:16:41 PM

thanks,
that fixed that problem
until next time ( i give myself 10 min)

Title: Re: im lost
Post by: Tweakie.CNC on October 15, 2021, 12:46:38 AM

 :D :D :D