Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Toshio.K on August 13, 2021, 06:48:25 PM
-
Hello everyone.
For Mach4, how do you do "Run From Here"?
When I press the Feed Hold button, the "Run G cord From Here" button turns black and I can't press it.
Please tell me how to start at any position on the G Cord.
Please tell me in an easy-to-understand manner.
-
For Mach4, how do you do "Run From Here"?
When I press the Feed Hold button, the "Run G cord From Here" button turns black and I can't press it.
It suppose that you are starting a new program from that line, if you are at feedhold you are not at start..
When I press the Feed Hold button, the "Run G cord From Here" button turns black and I can't press it.
You need to be in idle mode to use "Run From Here".
-
Answer Hello Greekart.
I clicked on the "Feed Hold" button propertues.
It was in the state of the photograph, but it does not improve.
Please tell me the solution.
-
Not for the feed hold button..
Just stop running any file, select a line you want to start and press run from here.
-
Yes.
I know how to do that.
in short,
1, Stop
2. Put a line in Line.
3, rotate the spindle.
4, Cycle Start
・ For Mach3
1, Feed Hold
2, designation of arbitrary line
3, Cycle Start
Does Mach4 not work in the flow of 1, 2 and 3 like Mach3?
-
・ For Mach3
1, Feed Hold
2, designation of arbitrary line
3, Cycle Start
Does Mach4 not work in the flow of 1, 2 and 3 like Mach3?
I don't see the point for that and i never had try it.
Change the enable state of "Run from here" to enable always and give a try if it will work.
Mach4 when feedhold is just paused, you can't do much in that state, no motion e.t.c.