Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Greekart on July 03, 2021, 07:18:12 AM
-
Hi, everyone. I search everywhere and i can't find answers.
Problem with mcTHC module:
When i call M5 (Torch off) in g-code not raise Z axis for the next location and every time changes from G90 to G91.
Is a module bug, can i update it somehow?
Only solution i can think about is to remove mcTHC function from M5 macro and write a custom one. This is the only solution?
Thanks in advance, Panos.