Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: Bixby on June 11, 2021, 02:55:50 PM

Title: sorry mach3 question
Post by: Bixby on June 11, 2021, 02:55:50 PM

X homes perfectly Z homes perfectly. Y axis gives device error triggered when it reaches proximity switch. A axis is slaved to Y.   I’ve tried setting the debounce very high   No joy!  This is a wixhc USB controller and everythiyng else works. I’ve been trying to solve this for over a year off and on. I’d love to be able to home this. Any suggestions welcome. Thanks!

Title: Re: sorry mach3 question
Post by: joeaverage on June 11, 2021, 10:02:12 PM

Hi,
I posted a response on the Mach3 board.

Note that your motion controller does not have a Mach4 plugin and therefore cannot be used with it.

Craig