Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: image4youuk on May 21, 2021, 03:07:24 PM

Title: G code in larges it self
Post by: image4youuk on May 21, 2021, 03:07:24 PM

Hi so my design is only 40mmx40mm but when I start it going it in larges it to more like 80mmx80mm any ideas would be helpful please

Title: Re: G code in larges it self
Post by: ZASto on May 22, 2021, 03:05:35 AM

Settings of your axes.
If you bought a cheapchineese machine, you should first tune it.