Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Bruce Hodgkins on May 17, 2021, 06:38:52 PM

Title: mach connection to rnr motion board
Post by: Bruce Hodgkins on May 17, 2021, 06:38:52 PM

Hi power was cut several times to the rnr controller.  Port 1 disconnected during this issue now Mach 3 refuses to talk to the controller other than the spindle. Any ideas??
Cheers Bruce

Title: Re: mach connection to rnr motion board
Post by: Bruce Hodgkins on May 17, 2021, 08:51:00 PM

Thanks I have sorted problem