Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: zune92 on April 21, 2021, 03:51:34 AM

Title: Jog mode vs. Program mode
Post by: zune92 on April 21, 2021, 03:51:34 AM

I make a homemade milling router and i adjust motor tuning and everything and in jog mode everything works fine,but when i change to program mode and insert g-code motors are producing bad sound and dont work good, they are folowing the conture i adjust motor steps and the path is ok, but the sound of the motors isn't. What can be the cause of that?,pls help.

Title: Re: Jog mode vs. Program mode
Post by: Graham Waterworth on April 21, 2021, 08:59:24 PM

The Jog rate might be set at something less than 100%, Press the TAB key on the keyboard and make sure Jog is at 100% then retune your motors, making sure steps per are set correctly.

You can check movement with a Dial Clock and enter this code in MDI screen :-

Metric, Move 1mm from current position
G01 G91 X1. F25.

Inch, Move 50 thousands from current position
G01 G91 X.05 F1.