Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: prcfab on March 31, 2021, 01:08:59 PM

Title: Mach 3 rapid clearance question
Post by: prcfab on March 31, 2021, 01:08:59 PM

Wondering why my rapid clearance dose not always work . It is correct in the G code Z of 1.00 and it always works when i dry run with torch turned off but with torch turned on it drags on the sheet even tho the g code is correct . Any ideas ?

Title: Re: Mach 3 rapid clearance question
Post by: TPS on April 03, 2021, 11:37:04 AM

maybe THC is enabled?