Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: gromit68 on October 11, 2007, 05:37:59 PM

Title: network setup, and how to run G100.m3p file
Post by: gromit68 on October 11, 2007, 05:37:59 PM

setting up a g100 under mach 3....

in setting up the network, I assigned 192.168.1.100 to the pc.
when I ping 192.168.1.10 , I get the message request timed out.
the setup guide  indicates this to be a cabling problem, but I am using a brand new network crossover cable bought from staples, connects the pc directly to the g100.
comments?

also, when I try to run G100.m3p, winxp asks me what to open it with.
Huh? the setup guide makes no reference to this.

Title: Re: network setup, and how to run G100.m3p file
Post by: Chaoticone on October 11, 2007, 06:07:33 PM

Did you place the G100m3p folder in your Mach folder and double click it? What version of Mach are you runnig?

Brett

Title: Re: network setup, and how to run G100.m3p file
Post by: gromit68 on October 12, 2007, 09:22:20 AM

I'm Currently using 1.84.001
I put the the file g100.m3p in the mach3 folder
when I double click it, windows asks me what to open it with.

Title: Re: network setup, and how to run G100.m3p file
Post by: Chaoticone on October 12, 2007, 09:52:45 AM

Download the latest version of Mach please. Also, make sure you have Mach installed on your C drive.

Brett

Title: Re: network setup, and how to run G100.m3p file
Post by: gromit68 on October 20, 2007, 02:14:23 PM

setting up a g100 under mach 3....

in setting up the network, I assigned 192.168.1.100 to the pc.
when I ping 192.168.1.10 , I get the message request timed out.
the setup guide  indicates this to be a cabling problem, but I am using a brand new network crossover cable bought from staples, connects the pc directly to the g100.
comments?

same problem found with 2nd pc, but same cable.
wondows recognizes a network connection, but when I ping 192.168.1.10, I get the message "request timed out"
again, the setup guide indicates a cabling problem.

any other suggestions?

Title: Re: network setup, and how to run G100.m3p file
Post by: gromit68 on October 20, 2007, 05:06:41 PM

I have made progress here...
Now I seem to have everything up to snuff, except, when I start mach3, the g100 is recognized for a few seconds, then I get the message communication lost.