Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: bijan on December 27, 2020, 07:59:21 PM

Title: mack 3 parallel port.
Post by: bijan on December 27, 2020, 07:59:21 PM

My machine loses the x,y, and z zero after a few minutes of work. please provide a remedy to fix this issue. Thanks

Title: Re: mack 3 parallel port.
Post by: Tweakie.CNC on December 28, 2020, 01:15:33 AM

Try reducing your Velocity and Acceleration settings by 50% in Motor Tuning and apply the changes for each axis. If this resolves the issue then increase your Velocity and Acceleration setting in small steps (using 'trial and error') until you get the best performance consistant with reliable operation.

Tweakie.