Machsupport Forum

Third party software and hardware support forums. => CS-Lab => Topic started by: cncwoodprojects on December 20, 2020, 01:56:49 PM

Title: CSMIO IP-M Z touch plate wiring
Post by: cncwoodprojects on December 20, 2020, 01:56:49 PM

Hi to all,

First thanks for your time and help.

I started to make a new controller box for migrate from GRBL to CSMIO IP/M and i have one doubt and i don't want to try things without understand it.

I have one simple touch plate with a clamp for a bit, but I'm afraid of make a bad use.
The problem i have I'm afraid of use pins IN 12 (11+ input pin) and IN25 (11- input Pin) with the chassis/spindle because are grounded to house earth and i don't know if this is possible.

(https://i.postimg.cc/w3GS83TW/probe-wiring-csmio.jpg) (https://postimg.cc/w3GS83TW)

I put this little schematic if someone can confirm how i need to wire the touch plate with clamp (or chassis without clamp) and confirm the pins used.

This thing it's the only i need for finish the controller box and continue to use my cnc.

Thanks to all i really appreciate your help and experience. 

Title: Re: CSMIO IP-M Z touch plate wiring
Post by: Graham Waterworth on December 20, 2020, 05:43:33 PM

Cs-Labs have connection diagrams on the site.

https://en.cs-lab.eu/tool-length-sensor-gnd-on-a-machine/ (https://en.cs-lab.eu/tool-length-sensor-gnd-on-a-machine/)

Title: Re: CSMIO IP-M Z touch plate wiring
Post by: cncwoodprojects on December 20, 2020, 07:11:08 PM

Thanks for your help,

It's necessary use second 24v PSU?