Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: BigRay on November 29, 2020, 02:08:39 AM

Title: Vacuum - on/off in standard router profile
Post by: BigRay on November 29, 2020, 02:08:39 AM

Hi,

I'm trying to use the vacuum button in the standard router profile in Mach 4. I went to "Edit Screen" and I couldn't seem to find an output drop down that can be used to assign an output on the controller, in this case Output 3.
I could see that it has a M100 and M101 attached to the button, so I tried to edit the output from 51 to 3 but this didn't work. I obviously didn't do it right and was wondering if someone might be able to tell me what I did wrong.

Thanks

Ray

Title: Re: Vacuum - on/off in standard router profile
Post by: coyhuber on December 08, 2020, 08:33:01 PM

Any help or comment?

Title: Re: Vacuum - on/off in standard router profile
Post by: Cbyrdtopper on December 09, 2020, 10:53:35 AM

Did you change the Output# to Output3 in the button in the screen and the macro?
That should be the only thing you need to do.  Change that number from 51 to 3 and you'll be good.