Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: kengentry707 on November 17, 2020, 10:07:26 PM

Title: Hicon Integra 7866 to Gecko G201
Post by: kengentry707 on November 17, 2020, 10:07:26 PM

I have purchased a used CNC machine with Gecko G201 drivers and want to use my Integra 7866 controller. After reviewing the knowledge base article showing sample wiring with Gecko G210 and G213V drivers I'm a bit unsure of the correct wiring. The G201 looks a little different so I wanted to verify the correct 7866 to G201 wiring.

I have attached the Gecko G201 manual.

Thanks,
Ken

Title: Re: Hicon Integra 7866 to Gecko G201
Post by: Vital System Support on November 18, 2020, 09:05:14 AM

Hello Ken

You can use the wiring of G210. Connect Dr- (direction-) and Sp- (step-) from the 7866 controller to the Gecko.  Connect +5V from the controller to the Common of the driver.

Title: Re: Hicon Integra 7866 to Gecko G201
Post by: kengentry707 on November 18, 2020, 12:40:01 PM

Thank you for the quick response! I will use the G210 wiring diagram.

Ken