Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: millman52 on October 03, 2007, 06:01:43 PM

Title: Sheetcam/Mach 3
Post by: millman52 on October 03, 2007, 06:01:43 PM
I am setting up sheetcam to use with mach3 for my plasma table.   After selecting mach plasma for the post processor, It then asks for G-code extention.  Sheetcam is defaulted to .tap extention. Is this correct or does it need changed to one of the other extentions?
Title: Re: Sheetcam/Mach 3
Post by: Hood on October 04, 2007, 03:33:59 PM
.tap should work just fine.
Hood