Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: KatzYaakov on July 24, 2020, 02:19:57 AM

Title: bad allocation error
Post by: KatzYaakov on July 24, 2020, 02:19:57 AM

i try load big nc file
after the file finish to load ,i got this error
never see
is some one matt such error?

Title: Re: bad allocation error
Post by: KatzYaakov on July 24, 2020, 02:41:48 AM

i try send here the file but its 25Mb cant send here
when i cut to half its let mach load it
but freinds its very confused because all chines cheap system can load such program only our cant??

Title: Re: bad allocation error
Post by: Graham Waterworth on July 24, 2020, 04:51:59 PM

What version are you using

Title: Re: bad allocation error
Post by: KatzYaakov on July 26, 2020, 04:52:44 AM

4.2.0.4300

Title: Re: bad allocation error
Post by: Brian Barker on July 27, 2020, 09:04:30 AM

25MB! How big is this thing! We can make a mode where it works but you will not have the toolpath and so on. You need some good hardware to make that happen.

Title: Re: bad allocation error
Post by: KatzYaakov on August 03, 2020, 01:36:57 AM

its not such big(as you can see at atach i can use ony half part ,if i not cut the file its cant load)
what do i need to do to run this complete file?