Machsupport Forum

Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: trike2 on May 28, 2020, 07:47:49 PM

Title: write wizard
Post by: trike2 on May 28, 2020, 07:47:49 PM

I can use the write wizard to engrave but when I save the .tap file and load it again, it put a bunch of circles in the cut. I am renaming the default "write.tap" file so I can find it again. It seams to be adding lines of code. I would like to not have to rewrite every time.

Title: Re: write wizard
Post by: Tweakie.CNC on May 29, 2020, 01:05:11 AM

To remove the 'crop circles' change the IJ Mode (Config. / General Config.).

(Ideally all Gcode files using arcs should contain the G90.1 / G91.1 as appropriate).

Tweakie.