Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: tommychenAJ on April 03, 2020, 02:26:10 AM

Title: Mach 3:G-code can't load correctly
Post by: tommychenAJ on April 03, 2020, 02:26:10 AM

Hi, everyone.I’m the beginner of operating CNC .

Recently, When I loaded G-code into Mach3 and pulled the scrollbar from up to down. I found G-code lagged at a strange place, and it couldn’t show all of my G-code. However, when I separated every steps and loaded each of them into Mach 3 .It ran perfectly. I not sure why this happened.

Title: Re: Mach 3:G-code can't load correctly
Post by: Tweakie.CNC on April 03, 2020, 03:16:02 AM

I have sent you a PM.