Machsupport Forum

Mach Discussion => VB and the development of wizards => Topic started by: Tarak on September 18, 2007, 06:28:11 AM

Title: 2nd Parallel port card - Outputs....
Post by: Tarak on September 18, 2007, 06:28:11 AM

Hey guys, another basic one for you, I've looked everywhere.
I know for 1 parallel port the outputs are controlled like this:

ActivateSignal(Output1)
DeactivateSignal(Output1)

But what commands do you use for a 2nd parallel port to use the outputs.
hhmmmmmmmmmmmm

Title: Re: 2nd Parallel port card - Outputs....
Post by: Chaoticone on September 18, 2007, 06:36:03 AM

I'm not sure about this but, your not calling a pin number, your calling an output. Should be the same for the second port I think. What is it labbled as in ports and pins, outputs?

Brett

Title: Re: 2nd Parallel port card - Outputs....
Post by: Tarak on September 18, 2007, 07:05:23 AM

Thanks Brett, now that I've looked properly.....That was a really DUMB question..................Ha...........

Title: Re: 2nd Parallel port card - Outputs....
Post by: Chaoticone on September 18, 2007, 03:46:51 PM

NP Darc, we all do it at times. I like to call it tunnel vision.  :)

Brett