Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: dprats on December 12, 2019, 01:22:34 PM

Title: MACH4 ShuttleXpress v2 inner wheel ONLY X JOG
Post by: dprats on December 12, 2019, 01:22:34 PM

Hi,

Just now I´m migrating from MACH3 to 4.
I´ve installed the MACH4 ShuttleXpress plugin, and all seems that works OK.
I´configured the buttons to change JOG [AXIS] , and all works.
BUT....
The inner wheel only moves the X AXI. Always only move the X.
The Diagnostics and LOG of inner wheel seems OK.

Somebody can say where I´ve to configure it???

Thanks a lot in advance.

Title: Re: MACH4 ShuttleXpress v2 inner wheel ONLY X JOG
Post by: dws on December 13, 2019, 09:49:28 PM

I am not sure if this info helps. This is for the Shuttle Pro V2 and not the Shuttle Xpress. This video shows how to configure the MPG for the inner wheel:

https://www.youtube.com/watch?v=lQmi6Q_iOAU

Title: Re: MACH4 ShuttleXpress v2 inner wheel ONLY X JOG
Post by: dprats on December 14, 2019, 03:32:36 PM

Thanks,
I've configured the MPG for the 3 axis , but only moves the X AXI.
With the outer wheel , I can select any AXI, if I have selected Y or Z, the outer moves the Y or Z, but the inner moves only the X.
It's very rare.

May be some problem with the PLUG IN ??
Where can I get the last plugin for MACH4 ???

Title: Re: MACH4 ShuttleXpress v2 inner wheel ONLY X JOG
Post by: dprats on December 14, 2019, 03:42:15 PM

OHHH!!! Thanks !
All solved.
I was assigning three MPGs.
All works OK.

Thanks a lot!!!!