Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: mcardoso on December 11, 2019, 09:44:57 AM

Title: Screw Mapping Support
Post by: mcardoso on December 11, 2019, 09:44:57 AM

Hi All,

Easy question here... Is screw mapping supported in Mach 4 Hobby?

Thanks,

Mike

Title: Re: Screw Mapping Support
Post by: Cbyrdtopper on December 11, 2019, 10:52:08 AM

Mike,
It is supported in industrial, not in hobby.

Title: Re: Screw Mapping Support
Post by: mcardoso on December 11, 2019, 12:50:52 PM

That's what I thought wasn't sure if things have changed since that comparison matrix was published years ago.  Is hobby still limited to 1 OB axis too?

Title: Re: Screw Mapping Support
Post by: joeaverage on December 11, 2019, 12:55:04 PM

Hi,

Quote

Is hobby still limited to 1 OB axis too?

Not according to smurph, in fact it was never restricted to one OB axis.

Craig

Title: Re: Screw Mapping Support
Post by: mcardoso on December 11, 2019, 03:38:46 PM

Smurph corrected me. The 1 OB axis was for Mach 4 Lite. The comparison chart states this incorrectly as Mach 4 hobby.

https://www.machsupport.com/wp-content/uploads/2014/06/Mach%20Version%20Differences_doc_a9.pdf

Mach 4 Hobby does suppprt 6 OB axes.