Machsupport Forum

General CNC Chat => Show"N"Tell ( What you have made with your CNC machine.) => Topic started by: mcardoso on December 09, 2019, 02:36:41 PM

Title: Practice Part
Post by: mcardoso on December 09, 2019, 02:36:41 PM

2x4x2" PVC. 9 Tools 10 Operations. All tools preset in control.

Pictures Attached

Title: Re: Practice Part
Post by: Tweakie.CNC on December 10, 2019, 01:48:08 AM

Excellent work.

Just one point, it's probably the camera angle, but that chamfer does not look concentric.

Title: Re: Practice Part
Post by: mcardoso on December 10, 2019, 09:01:56 AM

Tweakie,

You're very observant :) Not sure what happened there. All of the other chamfers look great. My guess would be that the drilled hole is slightly off center. I did a small spot drill followed directly by a 1/2" drill. The spot drill may have never centered the bigger drill up.

It doesn't look quite as bad from other angles. You can sure count on your chamfers to tell you where you screwed up!

Title: Re: Practice Part
Post by: mcardoso on December 10, 2019, 09:03:51 AM

Picture Attached

Title: Re: Practice Part
Post by: Tweakie.CNC on December 10, 2019, 10:03:03 AM

I think you are right, it looks like drill drift when viewed from the top.

If everything of mine turned out as good as that I would be well pleased - keep up the good work my friend.

Tweakie.

Title: Re: Practice Part
Post by: mcardoso on December 10, 2019, 09:12:18 PM

Thanks  ;D