Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: whizzo on September 15, 2007, 11:11:09 AM

Title: CNC4PC C10-BDBB
Post by: whizzo on September 15, 2007, 11:11:09 AM

Dear All,
            My first post on this forum  :)   I have been looking at Mach2/3 for some time now and I have been asked to retrofit a Bridgeport Series 1 CNC which has big stepper motors on it. The board mentioned above from CNC4PC claims it is capable of using pins 2 thru 9 as inputs. Does Mach 2/3 support this board ?

                                            Thanks in advance,

                                             David Winter.

Title: Re: CNC4PC C10-BDBB
Post by: poppabear on September 15, 2007, 03:08:16 PM

Yes, I use his boards they do well. BUT, note the bi directional is NOT isolated.

Title: Re: CNC4PC C10-BDBB
Post by: whizzo on September 16, 2007, 05:29:37 AM

Thanks for the reply Poppabear. Ithink I wasn't specific enough with my question though.
I probably should have said  " Does Mach 2/3 support this board using pins 2 thru 9  AS INPUTS ? "

                       Thanks again,

                       David Winter.