Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: luchito1973 on February 20, 2019, 08:16:23 AM

Title: Hicon integra synchronized threading with spindle encoder feedback
Post by: luchito1973 on February 20, 2019, 08:16:23 AM

hello experts.
The HiCON Integra motion controller supports full synchronized threading with spindle encoder feedback on mach3?
using G76 or G32 cycles.
 I have a ESS smoothstepper ethernet, but this card only supports single pulse index, works fine with short threads, but with long threads is not good.
thanks in anvanced.
luis.

Title: Re: Hicon integra synchronized threading with spindle encoder feedback
Post by: Vital System Support on February 22, 2019, 12:35:25 PM

Yes, the RPM is synched with the spindle encoder during threading.