Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: timmycnc on August 03, 2007, 12:19:49 PM

Title: Mach3 + G100 + other Plc devices
Post by: timmycnc on August 03, 2007, 12:19:49 PM

Hello, ;)

a question :-\

is it possible if jou already connected a G100 to mach3,

to instal other Plc devices on the same setup. ( I want more possibilities)
and a other question:

is it possible if jou already connected a G100 to mach3 + modiO board,

to install  another Plc devices on the same setup.

This question i ask, because I want buy a G100 and to extend my machine with a Plc such as a siemens S7-200/ S7-300

Title: Re: Mach3 + G100 + other Plc devices
Post by: haydms on October 07, 2007, 02:04:03 PM

Tim,
   How goes the quest to have a Siemens plc talking/residing with Mack? The reason I ask is I have installed and am in the process of testing a Siemens soft plc (WinAC V4.0) on my set up with mixed results (mainly in the I/O periphery image updates and not the cycle time).
   Maybe we could share notes?

Mark in the U.S.A.

Title: Re: Mach3 + G100 + other Plc devices
Post by: Chaoticone on October 07, 2007, 09:15:11 PM

Hey guys, I want to keep up with this topic. Using a PLC with Mach should be no trouble. Mach, PLC, and a G100? Good question.

Brett