Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: fvillar on October 23, 2018, 07:46:14 PM

Title: can any one help me to config mach3
Post by: fvillar on October 23, 2018, 07:46:14 PM

Hello to all and sorry for my bad english

So here is the problem
I have a desktop mill and I had to open the control box to check the spindle inverter and i found that there is a spindle conection on my control board

I have not been able to config mach3 to activate the spindle output

I am using the rnr eco motion pulgin to ake the machine move

thanks for your help